Product ID:36270 FLAT GRAY ACRYLIC LACQUER
MSDS Date:01/15/1993
FSC:8010
NIIN:01-270-3633
MSDS Number: BQYMZ

RANDOLPH PRODUCTS CO

701 12TH STT
CARLSTADT, NJ 07072
US

Emergency Phone: 201-438-3700

Info Phone: 201-438-3700

Preparer: SU

Cage: 77672

RANDOLPH PRODUCTS CO

830 CARLSTADT, NJ 07072-0830 US

Telephone: 201-438-3700

Cage: 77672

100.0 MM HG @

CAS: 71-55-6

RTECS: KJ2975000

Fraction By Weight: 10%

ACGIH TLV: 350 PPM/STEL 450 PPM

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

8.0 MM HG @ 20C)

CAS: 123-86-4

RTECS: AF7350000

Fraction By Weight: 10%

ACGIH TLV: 150 PPM/STEL 200 PPM

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS

70.0 MM HG

CAS: 78-93-3

RTECS: EL6475000

Fraction By Weight: 30%

ACGIH TLV: 200 PPM/STEL 300 PPM

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS

PROPYLENE GLYCOL MONOMETHYL ETHER ACETATE (SARA 313) (VAPOR

CAS: 108-65-6

RTECS: AI8925000

Fraction By Weight: 10%

OSHA PEL NONE ESTABLISHED

ACGIH TLV: 100 PPM

10.0 MM HG @ 20C)

CAS: 1330-20-7

RTECS: ZE2100000

Fraction By Weight: 5%

ACGIH TLV: 100 PPM/STEL 150 PPM

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS

Routes of Entry: Inhalation:YES Skin:YES Ingestion:NO
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:DRYING, CRACKING AND IRRITATION OF THE
SKIN. REACTS WITH SKIN PROTEIN AND MOISTURE AND CAN CAUSE RASH,
SCALING OR BLISTERING. HIGH CONCENTRATIONS MAY CAUSE HEADACHES AND
DIZZINESS, ARE ANESTHETIC, AND MAY HAVE OTHER CENTRAL NERVOUS
SYSTEM EFFECTS, INCLUDING DEATH.
Medical Cond Aggravated by Exposure:PRE-EXISTING SENSITIVITY TO
SOLVENTS CAN CAUSE A HEIGHTENED REACTION TO EXPOSURE TO THIS
PRODUCT. CONTACT LENS WEARERS SHOULD CONSULT PROVIDER BEFORE
HANDLING-CONSULT DR IMMEDIATELY IF ANY EYE CONTACT

First Aid:INHALATION: REMOVE TO FRESH AIR, RESTORE BREATHING. CONSULT A
PHYSICIAN. SKIN: FLUSH WITH WATER. EYE: FLUSH IMMEDIATELY WITH
LARGE AMOUNTS OF WATER. CONSULT A PHYSICIAN. DO NOT INDUCE
VOMITING. KEEP P ERSON WARM, QUIET AND GET MEDICAL ATTENTION. SMALL
AMOUNTS OF THE LIQUID ASPIRATED INTO THE RESPIRATORY SYSTEM DURING
INGESTION, OR FROM VOMITING, MAY CAUSE CHEMICAL PNEUMONIA OR
PULMONARY EDEMA.

Flash Point Method:SCC
Flash Point:21.0F,-6.1C
Lower Limits:1.0%
Upper Limits:15.%
Extinguishing Media:CARBON DIOXIDE, DRY CHEMICAL, FOAM.
Fire Fighting Procedures:WATER STREAM WILL SPREAD FIRE. DO NOT USE
WATER HOSE STREAM. FULL BUNKER GEAR IN FIRE AREA (HELMET WITH FACE
SHIELD, BUNKER COAT, GLOVES, RUBBER BOOTS).
Unusual Fire/Explosion Hazard:KEEP CNTNRS CLSD TIGHT-AWAY FROM HEAT-
SPARKS-OPEN FLAME. CLSD CNTNRS EXPLOD W/EXTREME HEAT-USE WTR TO
COOL. EVAC AREA. VAPORS TRAVEL TO IGNIT SOURCE/FLASHBACK.

Spill Release Procedures:AVOID BREATH SOLVENT VAPOR-HAVE ADEQ VENT.
AVOID SPARKS-FLAMES-ANYTHING FLAMM. IF SAFE ELIM SOURCE OF SPILL BY
CLOSING VALVE-PLUG HOLE, ETC. APPLY ABSORB INERT MATL TO
SPILL-CLEAN W/BRISTLE BROOMS-NON -SPARK TOOLS-CLEAN DRY RAGS. WEAR
PROTECT CLOTHES.

Handling and Storage Precautions:DRUMS SHOULD BE GROUNDED WHEN BEING
EMPTIED.
Other Precautions:PROVIDE RESPIRATORY PROTECTION AGAINST FUMES
GENERATED DURING BURNING.

Respiratory Protection:NIOSH/OSHA SUITABLE RESPIRATOR.
CHEMICAL/MECHANICAL FILTERS WHEN VENT RESTRICTED. PRECAUTIONS MUST
BE TAKEN SO THAT PERSONS DO NOT BREATHE THE VAPORS OR HAVE CONTACT
WITH EYES OR SKIN. PROTECT AGAINST EXPOSURE TO BOTH VAPOR AND
SPRAY MIST.
Ventilation:SUFF VENT IN VOL-PATTRN-KEEP AIR CONTAM BELOW PEL/TLV. RMV
SOLVENT VAPORS FROM LWR LEVEL WORK AREA. ELIM IGNIT SOURCES.
Protective Gloves:WEAR PROTECTIVE GLOVES.
Eye Protection:CHEM GOGGLES W/SIDE SHIELD-FACE SHIELD
Other Protective Equipment:USE PROTECTIVE CREAMS WHERE SKIN CONTACT IS
LIKELY. REMOVE AND WASH CONTAMINATED CLOTHING BEFORE REUSE.
Work Hygienic Practices:USE NORMAL HYGIENE PRACTICES DURING AND AFTER
HANDLING THIS MATERIAL.
Supplemental Safety and Health

HCC:F2
Boiling Pt:B.P. Text:162 TO 302F
Vapor Density:> THAN AIR
Evaporation Rate & Reference:IS SLOWER THAN ETHER
Appearance and Odor:THIN GRAY LIQUID, TYPICAL SOLVENT.
Percent Volatiles by Volume:66.4%

Stability Indicator/Materials to Avoid:YES
Stability Condition to Avoid:AVOID STRONG OXIDIZERS, ACIDS AND
ALKALIES.
Hazardous Decomposition Products:THERMAL DECOMPOSITION RELEASES CARBON
MONOXIDE AND/OR CARBON DIOXIDE.

Waste Disposal Methods:SOAK LIQ W/SAWDUST/RAGS-REMOVE. FLUSH W/WTR IF
POSS. AVOID SKIN CONTACT. DISPOSE IN ACCORD W/LOCAL-STATE-FEDERAL
REG. DO NOT INCINERATE-CUT-WELD EMPTY CNTNRS. WHEN DISCARDED MATL
IS HAZARD WASTE. TRAN S LIQ TO CNTNRS FOR RECOVERY/DISPOSAL. CODE:
F003.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.